SmarTek Systems SVS-1 User Guide-Part B - Manual (Page 31)

Set Output Video Text Display
This display is used to enter descriptive text which may be set to show on the output video image. Enter descriptive text in the text
box below the image. To change the text position, click on the text label in the image area (do not hold the button down) and move
the mouse pointer to the new location and click again. The X= and Y= labels show the position in pixels and may also be used to
change the text position by clicking in the upper/lower part of the field to increment/decrement the values. Holding the shift key
down while clicking will increase the increment/decrement value. Click the Show- button to turn the text On or Off in the output
video image. Click the Main Setup button to return to the Main Setup display.
X=0, Y=0
X=719, Y=479