SmarTek Systems SVS-1 User Guide-Part B - Manual (Page 4)

SVS-1 – Opening the SVS Set Line Zones Window
If a network connection is selected, set the SVS-1 IP address and Port
number in the SVS Network Connection screen. Click the Connect button
and note the connection status to make sure a connection was made. Keep
the Network Connection Window open.
1) Click in the upper/lower part of the Current SVS ID field to select the SVS ID (Camera Channel).
2) Click the SVS/Get SVS Parameters menu item. The yellow parameter warning label goes away.
3) Click the SVS/Get Image for Zone Setup menu item to open the Zone Setup window.
1
2 and 3