TechniSat TechniCorder ISIO STC - Manual (Page 14)

14
4.1 Mains power connection
The digital receiver should only be connected to the mains power supply once you have fin-
ished making all the connections to the various other components. This will prevent damage
to the digital receiver or other components.
a
Once you have made all the other connections in accordance with the following sec-
tions, use the power cable supplied to connect the receiver to 230 V/50-60 Hz mains
power outlet.
4.2 External unit
4.2.1 Operating the receiver with 2-4 DVB-S antenna signals
To be able to use the full scope of DVB-S functions on the digital receiver you should oper-
ate the receiver on up to four separate DVB-S antenna signals/antenna cables that which
are set up identically.
If you have not installed an additional DVB-S tuner module:
b, c
Connect LNB inputs 1 and 2 on the digital receiver to your external unit using
a suitable coaxial cable.
or if you have installed an additional DVB-S tuner module:
b, c, i, h
Connect LNB inputs 1 and 2 and LNB inputs 3 and 4 with your external
unit using a suitable coaxial cable.
Also see section 8.6 (DVB-S antenna setting) in your operating manual.
4.2.2 Operating with 1 DVB-S antenna signal
In exceptional cases you can also operate the receiver using just one DVB-S antenna sig-
nal. However, in this event the recording and PIP functions are only available to a limited
extent. (see section 8.6.3 in your operating manual).
If you have not installed an additional DVB-S tuner module:
b
Connect the LNB Input 1 of the digital receiver to your external unit using
a suitable coaxial cable
or if you have installed an additional DVB-S tuner module:
h, j, b
Connect the LNB Input 3 of the digital receiver to your external unit using
a suitable coaxial cable. Now also connect the loop out output with the LNB
input 1 .
Also see section 8.6 (DVB-S antenna setting) in your operating manual.
4.2.3 Operating with DVB-C/T antenna signals
The digital receiver can receive signals to DVB-C or DVB-T standard. Reception in parallel
with DVB-S reception is also possible
If you have not installed an additional DVB-C/T tuner module:
g
Connect the RF IN antenna input on the digital receiver to your external unit
using a suitable coaxial cable.
or if you have installed an additional DVB-C/T tuner module:
g, k, l
Connect the antenna Input RF INon the digital receiver to your external unit
using a suitable coaxial cable. Now also connect the loop out output with the
LOOP IN antenna input of the tuner module.