TechniSat TechniCorder ISIO STC - Manual (Page 48)

48
14 Encryption system
From this menu item you can access the submenus for the connected Smartcards and the
CI-/CI+ modules.
>
Call up Main Menu > Encryption System.
> Select one of the inserted CI-/CI+ modules in order to access its sub-menu, where
you can perform the settings.
Please note that the submenu now displayed is provided by the module and may
therefore differ from module to module.
14.1 Encryption system settings
CI dual encryption
CI dual encryption makes it possible to receive two encrypted channels at the same time
using only one CI module and a valid Smartcard.
>
Select the CI slot (CI1, CI2, CI1 + CI2 or auto (for automatic recognition) in which
the CI module for dual encryption is inserted or switch the function off.
Please also note that, to do this, both channels to be unencrypted must be located
on the same transponder, See also section 9.5.1 in your operating manual.
MHEG autostart
If an MHEG application is available for a transmitter, it can be started automatically.
>
To do this, activate the MHEG Autostart item to on.
PIN entry
Here you can save a PIN for the respective CI slot. This PIN is required to support DVR
recordings with parental control restrictions.
Manually initialising the CI/CI+ modules
> Press the green CI Reset function key to initialise the CI/CI+ module manually.