TechniSat TechniCorder ISIO STC - Manual (Page 35)

35
> Use the up/down arrow keys to move the selection bar over the channels and
select the highlighted channels with the OK button.
The selected channels appear with a check mark next to them.
> Highlight a selected channel again and press the OK button to remove this
channel.
A brief description of the highlighted channel appears on the right hand side.
> Use the yellow function key to select all channels.
> To finally accept your selection, press the green function button.
You can also change these settings later on at any time. You will find these options
in section 12 of your operating manual.
Loading EPG data
Your digital receiver contains an electronic programme information service
( ElectronicProgrammeGuide). You must first get the receiver to download the EPG data
from the satellite to enable electronic programme guide data to be displayed.
For this reason, the receiver will automatically start downloading the EPG data after the
channel list update or channel search is completed. This process can take up to 30 minutes.
> If you do not wish to wait for the EPG data, you can skip the process by pressing the
Info button.
The EPG data will then be updated automatically or you can update it at any time
manually.