TechniSat TechniCorder ISIO STC - Manual (Page 16)

16
4.5 USB port
The USB port is used for updating the operating software and to transfer data.
You can also use the film, music and image playback functions
(sections 9.18, 9.19 and 9.20 of your operating manual) to access MPEG, MP3 and JPG
files on the USB storage medium.
Your unit is equipped with an internal WLAN which enables wireless integration within your
existing WLAN network. However, if you wish, you can also use an external WLAN don-
gle for this purpose, e.g. the TechniSat USB WLAN adapter (item no. 0000/3633) or the
Technisat ISIO USB WLAN adapter (item no. 0002/3633) into the USB port.
When doing so please also note section 8.5.2 (WLAN settings) in the instruction manual.
It is also possible to use a Bluetooth dongle, for example to connect a Bluetooth audio
receiver with the receiver.
4.6 SD / MMC card reader
The SD card reader is used for updating the operating software and transferring data
(DVR recordings or image, music and video files) to or from the hard disk.
You can also use the image, music and film playback functions (sections 9.18, 9.19
and 9.20 of your operating manual) to access the corresponding files
on the SD / MMC card.
4.7 Network port (RJ45)
f You can use the network port to connect the receiver to your existing network. This
allows you to use the watchmi and internet functions, the UPnP functions, to access
network drives and to use the channel provider's HbbTV applications. You can also
record onto and playback from network drives.
When doing so please also note section 8.5 in your operating manual (Network
Settings).