TechniSat TechniCorder ISIO STC - Manual (Page 17)

17
5 Basic operation
Dear Customer
The following section starts by covering basic operation as well as recurrent operating steps
for the TV. This should make it easier to read the instruction manual, since it avoids repeat-
ed description of identical steps at each individual stage.
If a function or setting for the device has to be different from the basic operation, the differ-
ence in operation is described in detail at the relevant point in the instruction manual.
The so-called "On Screen Display" is used on your TV. This simplifies operation of the tele-
vision since the buttons on the remote control can take on different functions. This makes
it possible to reduce the number of buttons.
In this On Screen Display (in short OSD) the selected functions are highlighted.
Furthermore, you will see a line at the bottom edge of the screen in which the various but-
tons on the remote control are shown with their current functions.
In this instruction manual the terms shown in the OSD and the buttons to be
pressed are highlighted from other text by the print format shown.
Warning - indicates an important note which you absolutely should observe in order
to avoid problems with the unit or unwanted operation.
Tip - indicates a note about the function described as well as other functions associat-
ed with it and any others to be observed with reference to the respective place in the
instruction manual.
5.1 Switching the unit on/off
> When the receiver is on standby, you can switch it on by pressing the On/Standby
button on the remote control/on the receiver.
> When operating normally you can switch the unit into On/Standby mode by pressing
the On/Standby button.