TechniSat TechniCorder ISIO STC - Manual (Page 28)

28
> Use the right/left arrow keys to select whether you have connected1,2,3 or 4
DVB-S antenna signals.
> Press the OK button to accept the selection.
The setting options are dependent on your tuner configuration. Also see section 3.2
(Using an optional tuner module).
Antenna configuration (DVB-S)
In this step of the installation you can adapt your digital receiver set-up to the configuration
of your antenna (DVB-S).
> If you wish to accept the standard antenna setting, press the OK button.
> If the configuration of your reception equipment does not conform to the default set-
ting, press the Options button.
> Now perform the antenna settings as described in section 8.6 of your operating man-
ual in more detail according to your receiver system, then press the Back button to
return to the antenna configuration overview.
> Then press the OK button to accept the selections.
Antenna configuration (DVB-T)
If you use an active DVB-T antenna that does not have a separate power supply, or you do
not wish to use this, the amplifier for the active antenna can be supplied from your receiver
via the coaxial cable. To do this, set the antenna feed to On.