Aiwa XR-MD95 - Manual (Page 18)

RECORDING ONLY ONE TRACK
O P A C O To stop recording before the end of the track
Press the ■ button. Recording stops, and the contents (TOC)
of the recording are recorded on the MD.
To stop play of the CD, press the ■ button again.
To record on a previously recorded MD
If there is an unrecorded section left on the MD, the new recording
automatically starts from where the previous recording finished.
If you want to start recording from the beginning of a previously
recorded MD, erase the previous recording completely. (See
page 26.)
To change the display during recording
Press the DISPLAY button. With each press of the button, the
display changes in the following order,
r^® Track number and elapsed time of CD
(Example: CD fTr 2:34)
® Remaining playback time of CD
(Example: CD -3:37)
® Track number and elapsed time of MD
(Example: MD 4Tr 5:12)
Remaining recordable time of MD
(Example: MD -62:37)
1 Load a recordable MD into the disc drive with the
label side up and in the direction of the arrow.
Direction guide
№
2 Press the CD button on the control panel.
3 Load the CD to be recorded.
4 Play back the track to record.
Press the numbered buttons on the remote control. Or select
the track with the ◄◄ / ►► buttons on the control panel
and press the ► button.
5 Press the CD ► MD button to start recording.
►MD Tr REC
Recording stops automatically when the track ends.
When recording stops, "TOC Edit" is displayed and the contents
(TOC) of the recording are recorded on the MD.
1 8
ENGLISH