Aiwa XR-MD95 - Manual (Page 32)

TROUBLESHOOTING GUIDE
If the unit fails to perform as described in these Operating
Instructions, check the following guide.
GENERAL
There is no sound.
• Is the AC cord connected properly?
• Is there a bad connection? (-> page 4)
• Was an incorrect function button pressed?
Sound is emitted from one speaker only.
• Is the other speaker disconnected?
Sound becomes inaudible suddenly.
-» The protection circuit was activated due to an internal heat
build-up. Turn of the power, make sure there is sufficient
clearance behind the ventilation openings on the rear, and
leave the system until it cools down.
An erroneous display or a malfunction occurs, or an error
message appears.
-► Reset the system as stated below.
TUNER SECTION
There is constant, wave-like static.
• Is the antenna connected properly? (-♦ page 5)
• Is the signal weak?
-r Connect an outdoor antenna.
The reception contains noise interferences or the sound is
distorted.
• Is the system picking up external noise or multipath distortion?
-► Change the orientation of the antenna.
-► Move the system away from other electrical appliances.
MD RECORDER SECTION
The MD recorder cannot be operated.
• Is there a disc inside the CD player/MD recorder unit ?
-► Insert a disc.
• Is the lens affected by condensation?
-+ Wait approximately one hour and try again.
Sound is noisy.
• Is the system placed close to an object with a strong magnetic
field such as a television?
-> Move the system away from the television.
Sound is intermittent.
• Is the system placed on an unstable surface with a lot of
vibration?
-*■ Place the system on a stable surface with no vibration.
Recording is not possible.
• Is digital recording attempted from a source other than a CD?
• Is a prerecorded disc inserted?
-r Change to a recordable disc.
• Is the disc protected by the record-protected tab on the disc?
(-* page 16)
A hole CD or a hole track of a CD is not recorded onto an
MD.
-> An MD error or CD error has occurred during recording and
the recording has stopped. Erase uncompleted recording
and repeat the recording procedure from scratch.
CD PLAYER SECTION
The CD player does not play.
• Is the disc correctly inserted? (-♦ page 11)
• Is the disc dirty? (-► page 29)
• Is the lens affected by condensation?
-* Wait approximately one hour and try again.
To reset
If an unusual condition occurs in the display window, reset the
system as follows.
1 Press the POWER button to turn off the power.
2 Press the POWER button to turn the power back on while
pressing the ■ button. Everything stored in memory after
purchase is canceled.
If the power cannot be turned off in step 1 because of a
malfunction, reset by disconnecting the AC cord and repeat step
2 .
32
ENGLISH