Connections, Before connecting the ac cord, Important – Aiwa XR-MD95 User Manual
Page 4: Connections o
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CONNECTIONS
Before connecting the AC cord
The rated voltage of your system shown on the rear panel is 120
V AC. Check that the rated voltage matches your local voltage.
IMPORTANT
• Connect the speakers, antennas, and all optional equipment
first. Then connect the AC cord in the end.
• There are no differences between the front speakers. Both
speakers can be connected as L (Left) or R (Right).
1 Place the CD player/MD recorder unit on top of
the tuner/amplifier unit and plug in the connector
of the flat cable as shown below.
Note that the connector can be plugged in in only one direction
with the flat cable facing right.
2 Connect the speaker cords to the tuner/amplifier
unit.
The speaker cord from the right speaker should be connected
to the "R" jack and the cord from the left speaker to the "L"
jack.
After plugging in the connector, allow adequate clearance
between the flat cable and the ventilation openings.
AC cord
4
ENGLISH