ADLINK aTCA-N700 - Manual (Page 18)

aTCA-N700 HW Users Guide
１８
4.1.1. Headers and Jumpers
1) CPLD JTAG Header (J14): This header is used to reprogram the CPLD bit file using
a JTAG cable.
Figure 4-3 CPLD JTAG Header
2) COP-Header (J5): This header is used to access the LMP for a necessary
debugging situation to connect to the debug monitor.
Figure 4-4 COP Header
3) Standalone mode selector Header (J25): The header is used when a shelf manager
is not available. Put a cap on the header to connect pin 1 and pin 2 for stand-alone
mode.
Figure 4-5 Standalone Mode Selector Header