Figure 9-3 cold reset procedure, Figure 9-4 deactivate procedure, Table 9-4 signals: cold reset procedure – ADLINK aTCA-N700 User Manual
Page 62
aTCA-N700 HW Users Guide
62
Cold Reset triggered by Shelf manager
Figure 9-3 Cold Reset Procedure
(s) Shelf manager sends RESET command to IPMC.
① IPMC converts the command into Cold reset signal to FPGA.
② FPGA sends Resets to LMP and all Devices including RTM.
Table 9-4 Signals: Cold Reset Procedure
Signal name
Descriptions
Cold RESET
Cold RESET Command
0 : Cold RESET
1 : Normal operation
RESET RESET
Command
0 : RESET
1 : Normal operation
Deactivate
Figure 9-4 Deactivate Procedure
⒮ Shelf manager sends Deactivate to IPMC.
① IPMC sends Deactivate to LMP via PAYLOAD Interface (UART).
② LMP completes the operation and sends the completion message via
PAYLOAD Interface (UART) to IPMC.
③ IPMC initiates Power Down sequence to power off Front Blade and
RTM.