Echelon Neuron - Manual (Page 143)

Neuron Tools Errors Guide 135
NEX# Description
4004 Old-style dependency file <filename>. Use .nxdep instead [NEX#4004]
Old-style dependency file was specified. This file format is obsolete and
should not be used any longer. Use --nxdep.
4005 Ignoring superfluous .phd file (<filename>) [NEX#4005]
Ignoring superfluous .phd file. Both a new and a legacy linker dependency
file have been specified; the old format (.phd) is being ignored.
4006 The selected feature requires exporting a configured image (feature ignored)
[NEX#4006]
A feature was requested that can only be used with a configured image; use
the --state command to request exporting of a configured image.
4007 Cannot update dependency file <file> (<reason>). This might cause the build
status calculator to fail [NEX#4007]
The Exporter’s dependency file cannot be written due to the reason given in
the message. The file should be made writable to prevent the build status
calculator from failing.
4008 No boot ID was specified. A random value (<value>) is being used instead
[NEX#4008]
A boot ID value was not explicitly specified. To prevent multiple versions
of the same device to be exported with the same boot ID, the Exporter
automatically allocates a boot ID randomly (value shown in the message).
It is recommended to use the --bootid command to explicitly specify the
desired boot ID value, or to use the Project Make Facilities’ boot ID
management feature.
4009 The export configuration does not permit the authentication key, domain ID,
subnet ID, or device ID to be set. These will be ignored and the image will be
exported in the requested state [NEX#4009]
The image cannot be exported in the desired state with all data provided.
Superfluous data is being ignored, as the state has priority over the other
parameters. For example, this could occur if an image is to be exported in a
‘no domain’ configuration although a domain ID has been specified.
4010 The subnet/device ID has not been specified for the desired configuration. S/N =
1/1 is assumed [NEX#4010]
This warning will occur whenever an image is to be exported into the
cloned domain, without both subnet and device ID being given. A device
that has the clone domain flag raised must still have a valid
domain/subnet/device configuration. The warning indicates that the
problem has been recognized, subnet/device ID 1/1 are being assumed, and
the export continues.