Echelon Neuron - Manual (Page 173)

Neuron Tools Errors Guide 165
Code Description
49 Breakpoint in an ISR.
The error is logged, and the ISR context resets the device. Post-reset the
error is detected and the device’s state is changed to hard-offline. This is to
prevent a possible endless repetition of this condition.
50 System Image Write Protect.
Writes to the system image are trapped, the error is logged, and the device
resets.
129 Bad event.
This run-time error is checked only in the development environment. This
error could occur if the network configuration is invalid, if the network
management tool is malfunctioning, or if the Neuron Chip firmware image
is corrupted. If this error occurs, try reloading the device.
130 NV length mismatch.
This error may occur rarely due to network transmission problems. The
length of the data in a network variable update message is inconsistent
with the length expected by the device. Rebuild and reload the images if
this error continues to occur.
Note this error does not get set in conjunction with the change of a network
variable type for a NV of changeable type. However, if such type change is
performed in an inappropriate manner, this error might be logged upon the
first arrival of the incorrectly sized network variable data.
131 NV message too short.
This error may occur rarely due to network transmission problems. This
error could occur if a network message is corrupted.
132 EEPROM write failure.
This error may occur rarely due to Neuron Chip, transceiver, or application
failure.
This error occurs if too many erase/write cycles have been performed on the
EEPROM or flash memory. Up to 10,000 erase/write cycles per byte can be
performed in the on-chip EEPROM. This error will also be logged if an
EEPROM write is attempted when a device is online and has EEPROM
locking enabled.
133 Bad address type.
This error could occur if the network configuration is invalid, if the network
management tool is malfunctioning, or if the Neuron Chip firmware image
is corrupted. If this error occurs, try reloading the device.