Echelon Neuron - Manual (Page 165)

Neuron Tools Errors Guide 157
PMK# Description
4008 The file <file> (<full path>) was previously required for a build, but can not be
found. This might cause a build failure [PMK#4008]
The build status calculator recognizes a file that was required for a
previous build does not exist any more. This can possibly cause a build
failure, and it could be a normal situation after purposeful removal of the
file in question. For example, if the file in question were a .h file which is
no longer included by the NC code, then this would be normal. If the
#include statement still exists, then this might result in a compilation
failure.
4009 Unknown file type for <file> (<full path>) [PMK#4009]
The build status calculator was unable to determine the type of a file. This
indicates a corrupted dependency file. Proceed with build and attempt a re-
build.
4010 Can't open or write to build log file <file>. An existing build log file in this
location might be out-of-date as a result of this failure [PMK#4010]
Can't open or write to build log file <file>. An existing build log file in this
location might be out-of-date as a result of this failure. Verify that the
existing build log file is not write-protected.
4011 Cannot produce link summary. The linker mapfile <mapfilename> is
malformed. [PMK#4011]
Attempt to correct the problem with a "clean", followed by a re-build. If
PMK#4011 and PMK#4012 both appear together, attempt to address the
condition causing the PMK#4011 before attempting to address the
PMK#4012.
4012 Cannot produce link summary. The linker mapfile <mapfilename> is missing
[PMK#4012]
Attempt to correct the problem with a "clean", followed by a re-build. This
message might be a consequence of PMK#4011. If PMK#4011 and
PMK#4012 both appear together, attempt to address the condition causing
the PMK#4011 before attempting to address the PMK#4012.
4013 The requested action <action> overrides a previous choice. [PMK#4013]
This warning indicates that more than one, mutually exclusive, actions
have been requested on the command line. Actions are -build, -clean,
-compile, and -query. One and only one action must be given; a failure
occurs if none is given (PMK#107). The most recent action is performed if
more than one is given, noted with warning PMK#4013).