Hatteland Display 20 inch - HM 20T07 CMD - Manual (Page 18)

18
IND100078-20
General Installation Recommendations
Installation
EMI / Water Sealing Gasket (17 x 2 holes version)
This gasket is only applicable for NMD models. Comes with adhesive tape:
3M 9080-High Performance Non-woven Double Coated Tape.
To mount it correctly, please review the quick guide below.
1: Clean the bright surface with isopropanol as red area in FIG 2 shows.
2: Remove the protection paper from the gasket (FIG 1).
3: Now mount the gasket to the unit as shown in FIG 3.
Make sure that the holes in the gasket fits the guide pins
(on each side/top) and that it aligns with the holes in the
mounting frame.
4: Press firmly with two fingers around on the entire gasket
(FIG 4) to make sure it is glued properly and that possible
air bubbles are not present underneath the gasket.
FIG 2
FIG 3
FIG 4
FIG 1