Hatteland Display 20 inch - HM 20T07 CMD - Manual (Page 31)

31 User Controls
IND100064-19
BRIGHTNESS AND CONTRAST: (No function for DVI signals)
Selecting this function will enable the user to adjust brightness and contrast
for the display.
(No Function for DVI) BRIGHTNESS: Increase/decrease brightness level, total: 100 steps
(No Function for DVI) CONTRAST: Increase/decrease contrast level, total: 100 steps
COLOR TEMPERATURE :
Selecting this function will enable the user to modify the warmness of the picture.
Higher temperature = “cooler” picture. Lower temperature = “warmer” picture.
User can select between 9500K, 8000K, 6500K, and 5000K color temperature measured in
Kelvin degrees. Press “+” to access the sub-menu, where the RGB values can be adjusted.
Use “+” and “-” buttons to adjust these values, and “MENU” to exit. (Saving is done automatically)
FREQUENCY AND PHASE: (Some functions not available for DVI signals)
Selecting this function will enable the user to modify the image horizontal size and
fine tune the image quality.
(No Function for DVI) FREQUENCY: Increase/decrease the image horizontal size.
(No Function for DVI) PHASE: Fine tune the data sampling position (adjust image quality.)
(No Function for DVI) SHARPNESS: Increase/decrease video image sharpness level.
PICTURE TYPE : Motion / Still (Adjustment for best image quality)
If graphics on screen move a lot, select “Motion”
If graphics on screen are mostly still, select “Still”
STATUS:
Selecting this function will display graphic information such as resolution and
frequency.
POSITION: (No function for DVI signals)
Selecting this function will enable the user to position the image within the display
area.
(No Function for DVI) IMAGE UP/DOWN : Position the image vertically using “UP” or “DOWN” buttons.
(No Function for DVI) IMAGE LEFT/RIGHT : Position the image horizontally using “+” or “-” buttons.
OSD Menu Functions
2
2
1 2
1 2
1 2