Hatteland Display 20 inch - HM 20T07 CMD User Manual

Page 22

Advertising
background image

Physical Connections - HM 20T07 xxx

22

IND100133-30

0 1

MAIN POWER TOGGLE SWITCH:

For AC models the main power toggle switch provide secure 100% power off which means no physical/electrical

connection between power input and power module is possible. This differ from the soft-power on/off button on the

front of the product which only sends a electronic remote power switch signal to the internal power electronics.

For DC models, the switch act as a single pole power switch, thus only disconnecting power and not cutting both

power lines. When connecting / disconnecting any cables, please make sure to set the switch to 0 (off).

DVI-I IN:

Connect your DVI cable to the DVI-I 29P Connector (female). Fasten the DVI cable to the connector and make sure

you don’t bend any of the pins inside the connector when connecting. The DVI-I connector can function as regular

RGB IN by using a DVI-I -> RGB/VGA cable. For pinouts, see PIN ASSIGNMENTS chapter.

R G B

RGB OUT: (RGB - Circular BNC connectors)

This will enable a clone image output of the picture being displayed on the unit via the RGB IN. Connect your BNC

cable to the 3 x BNC Connectors (female) and connect the opposite to your equipment. Make sure the connectors is

firmly fasten and that you do not switch around the separate signals/colors for: R(to red color cable),

G(to green color cable) and B(to blue color cable). Note: RGB output is only suitable for use with RGB Sync on Green

signals.

R G B G B

RGB IN: (RGBHV - Circular BNC connectors)

Connect your BNC cable to the 5 x BNC Connectors (female) connect the opposite to your equipment. Make sure the

connectors is firmly fasten and that you do not switch around the separate signal/colors for: R(to red color cable),

G(to green color cable), B(to blue color cable) H(to horizonal sync gray color cable) and V(to vertical sync black color

cable).

Advertising
This manual is related to the following products: