Hatteland Display 20 inch - HM 20T07 CMD - Manual (Page 34)

34 User Controls
IND100064-19
UTILITIES:
Selecting this function will enable the user to configure the OSD menu, define
hot keys, verify BIOS Firmware version and miscellaneous operations.
USER SETTING: (Press “+” to access the sub-menu)
DPMS : Disable / Enable the DPMS function.
DISPLAY INPUT : Disable / Enable input source name upon power up.
AUTO SOURCE SELECT : Off = Disable auto source select function. (Default setting)
Low = Auto source select enabled ONLY in power up.
High = Auto source select ALWAYS enabled.
FILTER : Auto/On/Off - Signal Noise Reduction for Analog RGB1 Signal.
(Only available/functioning on custom models where required)
GAMMA : 1.0 / 1.6 / 2.2 - Adjusts gamma on TFT display.
SERIAL ADRESS : Set Serial Remote Channel from 0 to 15.
(Consult “Serial Communication (SCOM) Interface” chapter appendix)
OSD SETTING: (Press “+” to access the sub-menu)
OSD HORZ POSITION: Position the OSD menu horizontally.
OSD VERT POSITION: Position the OSD menu vertically.
OSD BACKGROUND : Choose between Translucent or Opaque (Default).
OSD ROTATE : Choose between Normal / Rotate. Will position the menu
either horizontally or vertically.
OSD MODE ; Only available in Advanced/Full menu!
“NORMAL” = ALWAYS shows the Simplified version of the
OSD menu. Company logo will be shown (top left corner).
“TOGGLE” = ALWAYS show the Advanced/Full version of the
OSD menu. Company logo will NOT be shown (top left corner).
(Please refer to the beginning of this chapter for information)
USER TIME OUT : Adjust the OSD menu time out period in a step of 5 seconds.
ZOOM: (Press “+” to access the sub-menu)
ZOOM LEVEL: Zooms in the display area from center.
HORIZONTAL PAN: Pan the display area horizontally.
VERTICAL PAN: Pan the display area vertically.
DIRECT ACCESS 1: (Press “+” to access the sub-menu)
Note: Some choices may not be available on all HM 20T07 models!
Define the hot key function for (“UP” or “DOWN” buttons) to one of these OSD functions:
Brightness / Contrast / Video Source / PIP* / No Function / Test Pattern / Rig for Black
* By pressing the hot-keys, the sequence of the selected input video source are:
Analog RGB1 / Analog RGB2 / DVI / Composite Video / S-Video.
NOTE: When assigning video source to hot key function, please set the “AUTO SOURCE SELECT” to HIGH (see above).
NOTE: Direct Access 1 default factory setting is NO FUNCTION
OSD Menu Functions
2
1 2
2
1 2
1 2