HITEC H4: DC/DC, Four-Port Multi-Charger - Manual (Page 14)

14
Hitec
Instruction Manual
5[UVGO5GVWR/QFG
We strongly recommend not changing the default 1C charge/discharge settings. If you choose to charge/discharge at a rate higher than 1C make
sure it is recommended by the battery's manufacturer.
5GV/KPKOWO+PRWV8QNVCIG
For safe operation, the user can select a minimum input voltage value. When the input voltage reaches the minimum or lower level during the charge/discharge
process, an ‘Error’ message will be shown and the operation will stop.
Second System Mode display screen (1) Second System Mode display screen (2)
Second System Mode display screen (3)
We highly recommend the minimum input voltage of 10.0V
9CTPKPI
5GV&KUJCTIG%4CVG#EEQTFKPI6Q$CVVGT[%CRCEKV[
The Hitec H4 has a default discharge C rate of 1.0, however this can be adjusted between 0.5C and 3.0C depending on the user's needs. It is recommended that
this rate always be set to the default. You can always adjust the charge rate during the individual battery charge / discharge setup procedure.
Set Push Button Sound
The H4 button sound can be switched to ON or OFF.
5GV%JCTIGCPF&KUEJCTIG/GNQF[1P1HH
Charge/Discharge End Melody can be switched to ON or OFF.