HITEC H4: DC/DC, Four-Port Multi-Charger - Manual (Page 17)

Hitec
Instruction Manual
17
.KVJKWO$CVVGT[%JCTIKPI
.K2Q.K(G.K+Q 3WKEM5VCTV2TQITCO
In menu of Battery type/capacity - When you press ‘ENTER’, charging function will activate right away.
When press ‘ESC/STOP’, menu will be moved to model memory menu.
Failure to properly setup your charging parameters increases the risk of a ſre or explosion that can result in property damage, injury or loss of life.
Before proceeding double check your setup to ensure it is correct.
Set up the charging Amps (A). The default charging Amperage is based
on 1C, however, if you want to charge at a higher you can set it here.
9#40+0) Do not charge at an amperage rate higher than what is
recommended by the battery's manufacturer. Please set up the exact battery capacity in mAh. Since the battery capacity is
interlocked with the charging Amps (A), the charging Amps is based on a 1C
charge rate (When the battery capacity increases by 100mAh, the charging
Amps will be increased by 0.1A ). When the battery reaches the target
capacity, the charge process will terminate automatically
When the set-up is complete, move the cursor to the Charge (for charging) or
Discharge (for Discharging) amperage setting and press and hold the ‘START’
button until the battery check screen appears. After checking, the H4 will display the battery type, number of cells, mAh
capacity and type of charging to be performed. If everything is correct and the
same as your battery, press the ‘START’ button to start the charging process.
If not recheck your set-up to ensure it is correct.
Next