HITEC H4: DC/DC, Four-Port Multi-Charger - Manual (Page 15)

Hitec
Instruction Manual
15
5OCTV&GVGEVCV$CNCPEKPI%JCTIG
QHHQP 
When battery balancer is connected to H4, each cell numbers will be detected automatically and start to charge without ſnal conſrmation screen. This function can
be selected ON or Off from system menu
ON: Check and conſrm the charge process automatically when selected battery cell numbers and detected battery cell numbers are same.
Off: Final check prompt will appear when before start to charge.(Dafault)
Default value is ‘off’ This function only can activate Li-Po and Li-Fe batteries. With turn to ‘SmartDetect’, provide more comfortable and easy.
+PEWTOCZ
+PRWVEWTTGPVNKOKV
Maximum current from power supply or power source battery can be adjusted by this function. In order to get maximum performance, please use 12V 500watts (Ap-
prx 40A) or more power supply or power source battery. Default sets 20A (Apprx 250W) for safety reason. If the Power supply capacity is lower than recommenda-
tion (below than 500W), please adjust max current to prevent overload or Shutdown. When H4 operate with vehicle battery on outdoor, please select max current
within vehicle battery max allowable current. To prevent get damage or malfunction, please do not extend or change H4 supplied wires.
5[UVGO5GVWR/QFG
5GV%JCPPGN$TKFIG(WPEVKQP
The Hitec Channel Bridge Function provides higher charge amperage for charging high capacity batteries faster. With this function, two 120W output powers can
transform into a single 240W output. Hitec's H4 allows for 4 different types of charge/discharge channel setup: ‘A,B,C,D’ , ‘A+B, C,D’, ‘A,B,C+D’ and ‘A+B, C+D’
Please refer to the section Hitec Channel Bridge Charging on page 30 for more details.
&KUECTF/QFG5VCTV
Discard mode is a feature used to prepare batteries for disposal. Refer to the section Battery Discard Mode on page 28 for more details on this function.
.CPIWCIG5GV
With the H4, you can choose from one of 5 different languages as the default. The choices are English, Spanish, German, Czech and Italian.
(CEVQT[&GHCWNV4GUGV
This resets the H4 to all factory defaults and erases any stored information. Press enter to see the prompt asking if you'd like to perform a factory reset. If you want
to proceed, hold down the Start/Enter button for 5 seconds to begin the reset procedure.
To exit the System Setup Mode, press the Stop / ESC key at any time.
5GV6GOR/QFG
The Temp Mode can be switched to C, [Celsius] or F,[Fahrenheit].
5GV$CEM.KIJV.%&1P1HH
The LCD Backlight setting can be set to Auto or can be turned ON or OFF. In Auto mode, the backlight will turn itself off after 5 minutes of inactivity.
5GV.%&%QPVTCUV
The Hitec H4 Multi Charger can set up LCD brightness. Levels are available from 0 to 8, with level 3 being the default level.