HITEC H4: DC/DC, Four-Port Multi-Charger - Manual (Page 16)

16
Hitec
Instruction Manual
.KVJKWO$CVVGT[%JCTIKPI
.K2Q.K(G.K+Q 3WKEM5VCTV2TQITCO
The previous charge setup is automatically stored in the memory for each channel. This makes it easy to repeat the charge process on the exact
same type of battery.
The Cursor above is on battery data memory number Each channel can be save 10 separate battery setups [0-9]
The Hitec H4 Multi Charger is designed to charge/discharge Lithium batteries: Lithium Ferrite (LiFe), Lithium Ion (LiIon) and Lithium Polymer (LiPo).
It is very important that you determine the type of battery you are charging and set the charging parameters correctly. It is important that the nominal voltage, ſnal
voltage, and battery capacity be properly set for the desired operation. Please refer to page 18 for more information.
Please select the exact battery type you want to charge on the screen. Press
the [V] button to continue. Now select the exact number of cells in your battery. Press the [V] button to
continue.
$CVVGT[%JCTIG&KUEJCTIG5GVVKPI/GOQT[5CXG.QCF
Whenever you setup a battery to charge or discharge the conſgurations is automatically saved. Each 4 independent channels can store 10 battery memories.
Channels utilizing a Channel Bridge can store and additional 10 battery memories.
An example of this feature is if you charge a 2,000mah 2cell Li-Po battery on memory number [0] it will automatically keep that setting using that memory number.
If you want to use a different number to memorize a different type of battery’s settings use the [ ] [ ] buttons to move the cursor to the Memory Number and use
the + or Ō to change the number, setup your battery and the conſguration is automatically saved. Later if you want to process the same battery, you just select data
memory number and press the start button.