HITEC H4: DC/DC, Four-Port Multi-Charger - Manual (Page 27)

Hitec
Instruction Manual
27
.GCF#EKF
2D $CVVGT[#FXCPEGF5GVWR
6JGRTGXKQWUUGEVKQPTGHGTTGFVQVJGSWKEMUVCTVOGVJQFQHEJCTIKPI.GCF#EKFDCVVGTKGU+PVJKUUGEVKQP[QWYKNNſPFKPHQTOCVKQPCDQWVſPGVWPKPI[QWT
UGVWRVQIGVVJGOQUVQWV[QWTDCVVGT[$GUWTGVQHQNNQYVJGDCVVGT[OCPWHCEVWTGTŏUTGEQOOGPFCVKQPUYJGPUGVVKPIWRVJGUGCFXCPEGFHGCVWTGU6QIGV
VQVJGCFXCPEGFUGVWRUETGGPWUGVJG
8 VQUETQNNFQYPVQVJGHQNNQYKPIUETGGPU
&%*)8QNV Set the Minimum Discharge Voltage
Use this function to prevent the decline of your battery’s life and performance. When used, over discharging will not occur. You should set the discharge voltage
according to the battery manufacturer’s recommendations. The default setting is 1.4V/Cell.
&%*)'PF Set the Discharge or Charge End Current (Auto or 60~500mA)
This sets the ſnal charge/discharge current at the end of the process. In ‘Auto’ mode, the process will terminate when the charging current goes to 1/10th of its initial
value. Otherwise, the charge current will be decreased until the designated value has been reached. The end current should be less than the initial charge current.
6TM%WTT Sets the Trickle Current Rate
When the charge process ends, current is fed to the battery to compensate for the natural discharge. Use this feature to set the trickle current rate. The function can
be turned OFF or adjusted between 50 to 300mA.
5CHGV[6'/2 Sets the Safety Temperature when using the optional temperature probe
You can monitor battery temperature during the charge/discharge process via the Temp sensor (sold separately). The default is set to 50°C (122°F) but can be
adjusted between 20°C to 80°C (68° to 176°F).
5CHGV[6KOGT Sets the maximum time the H4 will charge or discharge a battery
When you start to charge or discharge the battery, the H4's internal clock will start counting total processing time. By having a set safety time, the function will help
prevent battery damage from over charging or discharging. The default is set at 2 hours and can be set from 10 to 1,380 minutes.
/CZ%CRCEKV[ Sets the Maximum Battery Capacity in Percentage
The Hitec H4 Multi Charger provides battery capacity based on percentage (%). If somehow the battery has not been fully charged, you can charge your battery
according to the ‘Max Capacity’ rate.
The default is set at 100% and is adjustable between 50 to 150%.
Use this feature with caution to avoid over charging your battery which could cause the battery to explode.