HITEC H4: DC/DC, Four-Port Multi-Charger - Manual (Page 19)

Hitec
Instruction Manual
19
+PHQTOCVKQP&KURNC[GF9JKNG%JCTIKPI
&KUEJCTIKPI.KVJKWO$CVVGTKGU
The following section describes the various types of information available to you when charging or discharging lithium chemistry batteries. Use the ^ and v menu
buttons to scroll through the displays. When charging lithium chemistry batteries there are two types of charge/discharge screens, one is when the cell is connected
to the balancer, the other one is when it is not connected to the balancer.
When connected to the balancer, the main display indicates Charging Current, Current
Battery Voltage, percentage of charge, as well as the voltage of the individual cells. When not connected to the balancer,v the main display indicates Charging Current,
Current Battery Voltage, percentage of charge, Input Voltage, Output power and bat-
tery temperature if temp probe is connected.
5GEQPFCT[%JCTIG&KUEJCTIG5ETGGP
This screen displays the End Time, End Capacity, End Temperature: End
Voltage cutoff and CV Hold On/Off information. 5WOOCT[%JCTIG5ETGGP
This screen shows the type of process, current voltage and charge current of
the pack along with chargers input voltage and packs temperature if a temp
sensor is being used.
or
Use this feature with caution to avoid overcharging your battery which could cause the battery to explode.
% value from charge/discharge screen is showed just for your reference. It can be differed depending on battery condition
%8*QNF Sets the Constant Voltage Hold Mode
CV Hold Mode can hold the battery voltage even when the charging is complete. If CV Hold is ‘ON,’ the H4 charger keeps feeding a small amount of current to the
battery to prevent voltage drops. This function can be set ON or OFF. WARNING: It is recommended that you disconnect your battery immediately after the charge
or discharge process is completed.
/CZ%CRCEKV[ Sets the Maximum Battery Capacity in Percentage
The Hitec H4 Multi Charger provides battery capacity based on percentage(%). If somehow the battery has not been fully charged, you can charge your battery ac-
cording to the ‘Max Capacity’ rate. The default is set at 100% and is adjustable between 50 to 150%.