HITEC H4: DC/DC, Four-Port Multi-Charger - Manual (Page 24)

24
Hitec
Instruction Manual
0K/*0K%F$CVVGT[%[ENG/QFG
5CHGV[6KOGT Sets the maximum time the H4 will charge or discharge a battery
When you start to charge or discharge the battery, the H4’s internal clock will start counting total processing time. By having a set safety time, the function will help
prevent battery damage from over charging or discharging. The default is set at 2 hours and can be set from 10 to 1,380 minutes.
/CZ%CRCEKV[ Sets the Maximum Battery Capacity in Percentage
The Hitec H4 Multi Charger provides battery capacity based on percentage (%). If somehow the battery has not been fully
charged, you can charge your battery according to the ‘Max Capacity’ rate. The defa ult is set at 100% and is adjustable between 50 to 150%.
When you select NiCd or NiMH, as seen in the screen shot
above, the 'Cycle Mode Start' is shown on the bottom of
the screen.
Battery Cycle Mode can be used only with NiCd/NiMH types of batteries. When your battery performance is not at its optimal point due to long periods of storage or
improper charging, you can recover the battery’s performance by performing as series of charge / discharge processes with the Battery Cycle Mode.
Using the + or – button you can choose the number of cycles
you want the H4 to perform. You can select to repeat from 1 to
10 cycles. Press the V to move the cursor to the next prompt.
Move the cursor down until 'Cycle Mode Start' is high-
lighted. Press and hold the start button until the Cycle Mode
menu appears.
Here you can program where you want the cycle to start,
either Charge / Discharge or Discharge / Charge
0K/*0K%F$CVVGT[%[ENG/QFG
Use this feature with caution to avoid over charging your battery which could cause the battery to explode.