Labconco WaterPr BT Systems 90153 Series - Manual (Page 20)

Installation
12
Connection of the Power Cord − Turning on the System Power
A • Open the front cover of the system (A) – this may require removal of
the final filter. This will allow the system to go into STANDBY mode
once the system is powered.
B • Plug the Power Cord into the system (B).
• Plug the other end of the Power Cord into an appropriate source of
electrical power (i.e. wall outlet).
• Open the Feedwater Supply Valve.
Start-up Displays
C • Once the system is powered, the system will start to display
information before going into STANDBY mode (C).