Labconco WaterPr BT Systems 90153 Series - Manual (Page 36)

Using the WaterPro® BT System
28
RO Water Using the Tank Outlet Valve
A
TANK OUTLET VALVE
• On a WaterPro® BT (UV) system: RO Water is obtained from the Tank
Outlet. Open the Tank Outlet Valve when RO Water is needed (A).
How to Dispense an Exact Amount of Product Water (F01)
1 Press the Main and “-“ Buttons together
to enter the menu. The Display will
show F01.
2 Press the “+” or “-“ Button to adjust the
exact amount of Product Water (in
Liters) needed. Pre-set volumes of water
can be adjusted from 0.25 L to 9.75 L in
0.25 increments.
NOTE: The accuracy of this is dependent
upon the accuracy of the Flow
Calibration performed in Section How to
Calibrate the Flowrate from the
WaterPro® BT System (F02).