LINK Systems Omni II Automatic Setups Module - Manual (Page 10)

October 16, 2008 Manual Version 1.1
2-4
the password the operator can reset auto setup faults. This is the only auto setup related item to
which the operator has access. In order to load a die, the set-up personnel uses the RUN/PROG
key to recall a job from job memory. The set-up personnel will also be able to make changes to
auto setup parameters. Once the set-up personnel sets the die and verifies its correct operation,
the operator is left to run the die. If an auto setup fault occurs, the operator can enter the correct
password and then reset the fault. However, the operator cannot change any auto setup
parameter. This will allow the operator to keep running the job and reset faults that occur. If an
auto setup parameter needs changing, the set-up personnel must be called to change the
parameter.
The example above can be taken one additional step if two press operators are given different
user names and different passwords. One operator can be assigned the ability to change auto
setup parameters in addition to the ability to reset faults, while the other operator is not assigned
the ability to change parameters.
Section 2.2.3 Password Only Mode
The “Password Only” mode allows for sixteen users. Each user can be assigned access to some
or all of the restricted items. This mode does not use the RUN/PROG key.
The example listed above indicated that setup personnel required access to all restricted items.
In the “Key or Password” mode, the setup personnel used the RUN/PROG key to gain access to
all of the restricted items. In the “Password Only” mode, the setup personnel can still have
access to all of the restricted items, but the system must be configured as such. The setup
personnel must be assigned a user name and password. In addition, all restricted items would be
assigned access to the setup personnel.
Section 2.2.4 Key and Password Mode
The “Key and Password” mode requires the user to have the RUN/PROG key, user name, and
user password. Operation is basically the same as the Password only mode, except that in
addition to entering the password the user must switch the RUN/PROG key to the PROG
position.
Section 2.2.5 Restricted Items
The following table lists the auto setup module restricted items name and function.
AUTO SETUP MODULE RESTRICTED ITEMS
NAME FUNCTION
Auto Setup Reset Reset Auto Setup Faults
Auto Setup Settings Change Auto Setup Settings (Pressures, Slide Setpoints, etc.)