LINK Systems Omni II Automatic Setups Module - Manual (Page 16)

October 16, 2008 Manual Version 1.1
3-2
AUTO SETUP
NEU
GND
GND
L1
A
4
S
S
S
1
A
3
S
S
2
A
S
S
2
1
S
A
Figure 3-2 Faceplate
Section 3.1.1 Module Assembly
The OmniLink II Press Automation Control Automatic Setup module consists of a base board
and optional plug-on boards. Each plug-on board can either add one slide adjust or two air adjust
systems. For example if a system of one slide adjust and one counterbalance adjust is required,
the slide adjust plug-on board should be installed in the SS1 slot. The air adjust plug-on board
should be installed in the AS1 and AS2 slots. In this example only one air adjust system,
counterbalance adjust, is required. The AS2 air system will be present, but not used. Each plug-
on board is held on to the base card by four #6-32 screws. If not already assembled, install each
board on the base card putting slide adjust cards in SS1 or SS2 and air adjust cards in AS1 and
AS2 slot or AS3 and AS4 slot.
Section 3.1.2 Assigning Module Number
Up to four 5100-10 OmniLink II Automation Control Automatic Setup modules can be
connected. Each module must have its own unique Module Number. This selection is made by
use of the rotary switch that is located on the component side of the 5100-10 base circuit board.
See Figure 3.2. The numbers should be assigned sequentially starting at one. The system will
recognize number one through four. Two units cannot share the same Module Number.