LINK Systems Omni II Automatic Setups Module - Manual (Page 28)

October 16, 2008 Manual Version 1.1
3-14
Slide adjust motor starters with and without auxiliary contactors are supported. Solenoid air
valves for air motors are also supported. Refer to Appendix B for typical wiring diagrams.
Figures B.4 shows the wiring for an AMCI dual resolver. Figures B.5 and B.6 show the wiring
of slide adjust motor starters with and without auxiliary contactors. Figure B.7 shows the wiring
of a slide adjust air motor.
If remote Jog Up and Jog Down push buttons are used, they should be wired as shown in Figure
B.8. Since the OmniLink II Press Automation Control Automatic Setup module can support up
to two slide adjust systems, inputs are available for Jog Up and Jog Down push buttons for both
slide adjust systems. Normally, only one slide adjust system is required per press.
NOTE: The cable should remain unbroken except for the connector in this junction
box to the shield integrity – do not splice the cable.