LINK Systems Omni II Automatic Setups Module - Manual (Page 15)

October 16, 2008 Manual Version 1.1
3-1
Section 3 Installation
Section 3.1 Auto-Setup Module Installation
The OmniLink II Press Automation Control Automatic Setup module can be used with the
OmniLink II Press Automation Control system or with the OmniLink 5000 Press Control system.
This is illustrated in Figure 3.1. The Automatic Setup module connects to either system via the
high speed serial bus.
OmniLink II Press Automation Control
OmniLink II LCD
Operator Terminal
Resolver or
Resolver/Encoder
OmniLink II Press Automation Control
OmniLink II LCD
Operator Terminal
Po
we
r
C
onnection Module
Logic Module
R/D M
o
d
u
le
1st Input Module 2nd Input Module
Output D
riv
e
Hi
Speed
In
ter
face
Resolver/Encoder
OR
High Speed
Serial Bus
Cable
High Speed
Serial Bus
Cable
High Speed
Serial Bus
Cable
OTHER
OMNILINK
II
OPTIONS
(If Present)
OTHER
OMNILINK
II
OPTIONS
(If Present)
O
M
N
IL
INK II
A
U
TO SETUPS
High Speed
Serial Bus
Cable
OMINLINK II PRESS
AUTOMATION CONTROL
OMINLINK II 5000
PRESS CONTROL
Figure 3-1 OmniLink II Press Automation Controls Connections
The faceplate of the Automatic Setup module is partitioned with labels such as SS1, AS1, etc.
These labels represent the type of board that can be installed on the card at that location. SS1
and SS2 can have slide adjust boards installed. AS1 through AS4 can have air adjust boards
installed. Note that SS2 overlaps with AS1 and AS2 to allow a second slide adjust card to be
installed on a double action press at the expense of the two air slots, AS1 and AS2. The
faceplate is shown in Figure 3.2.