LINK Systems Omni II Automatic Setups Module - Manual (Page 50)

October 16, 2008 Manual Version 1.1
5-6
Section 5.1.3 Manual Slide Movement
Manual slide movement can be controlled by the JOG UP and JOG DN softkeys or by the
remote JOG UP and JOG DN pushbuttons.
Section 5.1.3.1 Manual Slide Movement by JOG UP & JOG DN softkeys
As noted in the section explaining the softkeys in the slide screen, the slide may be manually
moved by pressing the JOG UP and JOG DN softkeys. These keys will work regardless of
whether the slide system is on, off, or in manual mode. Note, however, that these keys will not
override the mechanical up and down limit switches in the slide. In addition, these keys will not
allow movement beyond the electronic limits entered in the configuration screen for the slide
unless the slide system is “OFF”.
Section 5.1.3.2 Manual Slide Movement by Remote Jog Up & Down Push Buttons
Optional remote Jog Up and Jog Down push buttons can be added to the slide adjust system. In
order for these push buttons to change slide adjust, the Slide Adjust OFF/ON selector switch
must be “ON.” These remote push buttons will work regardless of whether the slide system is
on, off, or in manual mode. Note, however, that these remote will not override the mechanical
up and down limit switches in the slide. In addition, these buttons will not allow movement
beyond the electronic limits entered in the configuration screen for the slide unless the slide
system is “OFF”.
Section 5.1.4 Slide Fault and Status
The last fault and current status of the slide system are displayed for diagnostic and
informational purposes. Under normal conditions “Fault” should be “None”. If there is a
problem with the slide system, it will be reported here. “Status” gives the current state of the
system such as “In Position”, Slide Low”, “Moving Up” etc. For the most part these messages
will be self-explanatory. See section 6 for a complete list of fault and status messages with
explanations.
IMPORTANT! Automatic movement will be terminated if the JOG UP softkey, JOG
DOWN, or CANCEL AUTO ADJUST softkey is pressed while the
slide is moving automatically. Automatic movement will pause if the
slide adjust switch is turned off. It will resume when the slide adjust
switch is turned back on.