Martin Christ RVC 2-33 CDplus - Manual (Page 23)

RVC 2-33 CD &
Set-up and Connection
Version 01/2009, Rev. 1.21 of 25/11/2013 - sb 23
Translation of the original operating manual
5 Set-up and Connection
5.1 Unpacking the Rotational Vacuum Concentrator
The rotational vacuum concentrator is packaged in a cardboard box
or in a wooden crate, depending on the scope of supply.
After opening the packaging, take out the box containing the
accessories.
Remove the packaging material.
Lift the rotational vacuum concentrator upwards. When lifting the
unit, always reach under the rotational vacuum concentrator from
the side.
The rotational vacuum concentrator
RVC 2-33 CD &
weighs approx. 44 kg!
5.2 Transport Safety Device
The rotational vacuum concentrator RVC 2-33 CD & is not
equipped with a transport safety device.
In order to prevent the lid from getting stuck during the transport,
several layers of paper are placed between the lid and rotor
chamber.
The paper must be removed prior to the unit’s start-up.
5.3 Installation Site
Operate the rotational vacuum concentrator only in closed and dry
rooms.
The table must be stable and have a solid, even surface.
Ensure sufficient ventilation. Do not place any paper or cloth
behind or under the unit, since otherwise the air circulation will be
impaired.
Keep a safety distance of at least 30 cm from the wall so that the
vents in the unit remain fully effective.
The allowable ambient temperature is +10°C to +25°C.
Do not position the rotational vacuum concentrator near heat
generators.
Avoid direct sunlight (UV radiation).