Altera Remote Update IP Core - Manual (Page 36)

read_
para
m
write
_
para
m
read_source param Remote Update Operation data_out
width
(bits)
MSM Mode
1 0 [00] [000] Master State Machine Current State Mode
(Read Only)
• 00—Factory mode
• 01—Application mode
• 11—Application mode with Master State
Machine User Watchdog Timer Enabled
2 Factory or
Application
1 0 [00] [100] Read factory boot address 24 Factory
1 0 [01] [100] Read Past Status 1 boot address.
For more information, refer to Figure 11 .
24 Factory
1 0 [01] [111] Read Past Status 1 reconfiguration trigger
condition source.
For more information, refer to
Figure 11 .
5 Factory
1 0 [10] [100] Read Past Status 2 boot address.
For more information, refer to Figure 11 .
24 Factory
1 0 [10] [111] Read Past Status 2 reconfiguration trigger
condition source
For more information, refer to
Figure 11 .
5 Factory
1 0 [01] [010] Read current application mode watchdog
value
29 Application
1 0 [01] [011] Read current application mode watchdog
enable
1 Application
1 0 [10] [100] Read current application mode boot address 24 Application
0 1 [00] [001] Write the early
confdone
check bit.
All parameters can be written in factory
mode only.
1 Factory
0 1 [00] [010] Write the watchdog time-out value.
All parameters can be written in factory
mode only.
12 Factory
36 Remote Update Operation
UG-31005
2015.04.07
Altera Corporation Altera Remote Update IP Core User Guide
Send Feedback