Altera Remote Update IP Core User Manual
Page 42
Date
Version
Changes
July 2013
2013.07.12
• Added Cyclone III and Cyclone IV Devices Remote
Update Operation.
• Updated Input Ports to include Arria V and Cyclone V
support for
data_in[]
port.
• Added Param[] as a standalone section.
• Updated Parameter Type and Corresponding
Parameter Bit Width Mapping to include Arria V and
Cyclone V support for Reconfiguration trigger
conditions parameter. Also updated Page Select
parameter to include information for Arria V, Cyclone
V, and Stratix V devices.
• Updated Parameter Type and Corresponding
Parameter Bit Width Mapping to update the Configu‐
ration Mode (AnF) information.
• Updated Input Ports to add a link to the Configura‐
tion, Design Security, and Remote Upgrades in the
Cyclone III Device Family chapter.
• Updated Input Ports to clarify that a falling edge of the
reset_timer
signal triggers a reset of the user
watchdog timer.
• Updated Output Ports to add Arria II, Arria V,
Cyclone V, Stratix IV, and Stratix V device support for
24-bit bus for
data_out[]
port.
• Added Knowledge Base section.
• Added Simulation to clarify that simulation capability
are for Arria GX, Stratix, and Stratix II devices only.
February 2012
3.0
Add Cyclone IV support for param[] parameter.
August 2010
2.5
Updated for Quartus II software v10.0, including:
• Updated the Device Family Support section.
• Add Parameters table to Specifications chapter.
• Added new parameters and ports to Specifications
chapter.
• Added new prototypes and declarations sections to
Specifications chapter.
• Updated design example figures and steps.
April 2009
2.4
Updated for Quartus II software v9.0, including:
• Updated the section.
• Added the Maximum Clock Frequency (f
MAX
) for the
supported devices.
• Updated ports and parameter tables.
42
Document Revision History
UG-31005
2015.04.07
Altera Corporation
Altera Remote Update IP Core User Guide