Casella CEL Airborne particulate monitoring system User Manual
Page 9
HB3256-03
Page 7
System wiring.
Basic system wiring is simple providing the manual is studied carefully and care is taken. Wiring
should only be carried out by qualified personnel who are familiar with the procedures and
precautions necessary when wiring such electronic devices.
Warning: INCORRECT WIRING MAY RESULT IN DAMAGE TO THE SYSTEMS OR
SENSORS. SUCH DAMAGE WILL BE THE CUSTOMERS RESPONSIBILITY AND IS
EXCLUDED FROM THE CONDITIONS OF WARRANTY.
Connection details for additional sensors are shown within the 'Optional Sensors' section of this
manual.
Position each sensor in their final position. Route the cables neatly back to the base of the
enclosure. Loosen and remove the cable gland lock nut. DO NOT REMOVE THE CABLE
GLAND.
Now thread the sensor cables through the enclosure cable entry holes and secure the cable gland
using the lock nut. Ensure the cables pass from the outside to the inside of the enclosure.
Testing the system.
Before apply power to the system, confirm all system wiring is correct.
To confirm operation of the system, it will be necessary to install and initiate the supplied
software, please refer to the software section of this manual for details.