CIRCUTOR CIReQ User Manual

Page 17

Advertising
background image

_______________________________________________________

_________________________________________________________________________________________________________

CIR-eQ User’s Manual

17 of 36

* See chapter 7. Quality events as an example.

After completing the configuration of CIR-e³, click on “Generate”.

When you select “Generate”, the software automatically creates file xxxxxxxx.xst in the

root directory of the SD card (stored in the default directory). The name file is the same

as the serial number of the unit entered in the setup menu, including the unit's

configuration and installation's characteristics, as shown on the following figure. The unit

will take this configuration when starting the measurements and the data will be recorded

from the SD memory card.

If you do not generate a setup file, store it in the root directory of the memory card or

when the CIR-eQ analyzer can not find the location of the memory card before the

parameter recording process starts, it will automatically load a setup file that has default

parameters defined. The default file loaded by the analyzer is called “Default” and its

features are described on the following figure.

Serial number: The serial number

of the setup file is the device’s

serial number.

Report name: The name of the

report is “Default”.

Register period: Established as 10

minutes

Primary voltage: The transformer's

primary value is 1 (direct

measurement)

Secondary

voltage:

The

transformer's secondary value is 1

(direct measurement)

Nominal voltage (Ph-n): The

standard nominal voltage is 230

Vac

Nominal Freq.: The standard

frequency is 50 Hz.

Over voltage level: The threshold

for detecting an over voltage is 110

%.

Sag level: The threshold for detecting a sag is 90 %.

Interruption level: The threshold for detecting an interruption voltage is 10 %.

Over voltage hysteresis: The over voltage hysteresis value is 2 %.

Sag hysteresis: The sag voltage hysteresis value is 2 %

Interruption hysteresis: The interruption voltage hysteresis value is 2 %

Advertising