CIRCUTOR CIReQ - Manual (Page 22)

_____________________________________________
_________________________________________________________________________________________________________
22 of 36 CIR-eQ User’s Manual
LED L1, L2 and L3 must be on before recording, as shown on the figure.
6.4.- START/STOP BUTTON
After following these steps and making sure that the unit is connected, hold the red
START/STOP button during 3 seconds to start recording the installation's parameters.
When you hold the START/STOP button, the REC LED will be lit, indicating that the
electrical parameters are being recorded as shown in the figure.
When you wish to stop the recording process, hold START/STOP during 3 seconds to
stop and end the recording.
When the memory card is full during a recording, the unit will automatically
change to the STOP mode and indicate the incident with the REC LED, which
will start flashing.
To read the STD and EVQ data stored in SD card the user has to insert the SD card in
the computer and open them with Power Vision or Power Vision +.
6.5.- SAFE EXTRACTION OF THE SD MEMORY CARD
To extract the SD card safely, make sure that the unit is not in the recording mode. The
REC LED must be off. If the REC LED is on or flashing, stop the recording by pressing
START/STOP before removing the SD card.
Removing the SD card while the unit is in the recording mode can
corrupt the file stored in the memory and render it illegible.