Pinnacle Systems STTS - Manual (Page 13)

7
JUMPER SETTINGS (metal box controller)
Computer Board: S5 O O O O O O O O
BOTTOM O O O O O O O O TOP
1 2 3 4 5 6 7 8
SHUNT(S) DEFINITION USAGE ( 1= JUMPER ON PINS)
1,2,3 # of mats in zone 1 1 MAT = 0,0,0 2 MATS = 1,0,0 3 MATS = 0,1,0
4 MATS = 1,1,0 5 MATS = 0,0,1 6 MATS = 1,0,1
7 MATS = 0,1,1 8 MATS = 1,1,1
4,5,6 # of mats in zone 2 0 MAT = 0,0,0 1 MAT = 1,0,0 2 MATS = 0,1,0
3 MATS = 1,1,0 4 MATS =0,0,1 5 MATS = 1,0,1
6 MATS = 0,1,1 7 MATS = 1,1,1
7,8 # of mats in zone 3 0 MAT = 0,0 1 MAT = 1,0
2 MATS = 0,1 3 MAT =1,1
Computer Board: S1 O
AUX O O
EXT O O
MAN O O
SHUNT(S) DEFINITION USAGE
S1 Fault reset
(Push Button) Resets fault codes (tries to re-initialize unit)
JP6-AUX N/A Not used at this time
JP6-EXT External relay checking active
for all zones used
E=Ext. relay checking
Apply jumper to activate function (message display
will add an E (ok E) to indicate you have selected
this function)
JP6-MAN Manual / Automatic reset for
all zones
M = Manual reset
Jumper forces manual push-button to re-energize
zone relays
(message display will add an M (ok M ) to indicate
you have selected this function)