Pinnacle Systems STTS - Manual (Page 4)

i
Proper Use and Limitations
The information disclosed herein includes proprietary rights of the manufacturer. Neither this document
nor the information disclosed herein shall be reproduced or transferred to other documents, used or
disclosed to others for manufacturing purposes, or for any other purposes, except as specifically
authorized in writing by the manufacturer. If this manual is supplied in connection with the sale or delivery
of manufacturer’s equipment, it is to be used solely for maintenance, repair, or installation of such
equipment.
The STTS was manufactured in the United States. The Installation Manual was printed in the United
States.
You must read and fully understand the following information pertaining to the proper use and limitations
of your STTS:
• The STTS must be installed by qualified personnel only.
• The STTS must NOT be used on full revolution presses or any machine that cannot be commanded
to stop at any time.
• You must NOT wire the Safety Output contacts of the STTS to an external relay unless you use the
External Relay Checking feature.
• The mechanical power press on which the STTS is installed must meet ANSI B11.1-2001and
OSHA 1910.217 regulations. These include inspection and maintenance procedures that must be
followed to comply with the regulations. The manufacturer will NOT take responsibility for
improperly maintained machinery.
• Point of operation safeguarding is defined in ANSI B11.19-2003. This regulation is used to
determine a safe distance to place your STTS. The manufacturer takes no responsibility for injury
as a result of improper safeguarding or improper safe distances.
• The STTS may not be able to safely stop a press which has a faulty stopping mechanism. The
manufacturer cannot be held responsible for an improperly maintained or faulty stopping
mechanism.
• The STTS must be checked before put into operation. Follow instructions provided in this manual
for procedures on how to do this.
• The STTS should never be modified or repaired except by qualified personnel and upon
authorization of the manufacturer. Never operate machinery that is not in full working order.
• Make sure that all maintenance people, machine operators, die-setters, foreman, and supervisors
have read and understood this manual and all procedures have been and will be followed.
• All procedures in this manual must be followed. The manufacturer cannot take responsibility for
operation if all procedures and warnings in this manual are not followed.
Warranty
Manufacturer warrants that this product will be free from defects in material and workmanship for a period
of 2 years from the date of shipment thereof. Within the warranty period, manufacturer will repair or
replace such products which are returned with shipping charges prepaid and which will be disclosed as
defective upon examination by the manufacturer. This warranty will not apply to any product which will
have been subject to misuse, negligence, accident, restriction, and use not in accordance with
manufacturer’s instructions or which will have been altered or repaired by persons other than the
authorized agent or employees of the manufacturer.
DISCLAIMER
The provisions of the paragraph "WARRANTY" are the sole obligations of the manufacturer and exclude
all other warranties of merchantability, expressed or implied. Further, there are no warranties which
extend beyond the above warranty.