Proceed PAV User Manual

Page 32

Advertising
background image

32

phase-induced irregularities at the crossover frequency of 80 Hz.) Of these
two guidelines, the first is usually more significant sonically, as it tends to
minimize the audibility of the room’s modes. Avoid corner placement, as this
typically increases bass quantity at the expense of bass quality (by stimulating
every room mode supported by the room).

The actual number of subwoofers used in an installation will depend on both
the size of the room and on the manufacturer’s design. Of course, having multiple
subwoofers enhances the maximum level at which they will play. Additionally,
there is an advantage to having more than one subwoofer in the room. Smoother
bass may be obtained by placing two subwoofers asymmetrically in the room,
since different sets of room modes would then be excited by each. The peaks of
one set of room modes could offset the valleys of the other one to some degree.

The Surround Speakers

Ideally, the rear speakers will create a diffuse, non-localizable soundfield which
envelopes the listener. Creating this effect depends in part on the loudspeakers
chosen for the job.

If THX-certified dipolar surround speakers are used, they should be located high
and to the sides of the listening area, firing to the front and the rear of the room.
(See diagram, below.) This placement ensures that the audience will not be able
to localize them as sources of sound, but rather will be enveloped in a diffuse
soundfield. They should be at least two feet above ear level when seated. Ideally,
they would be placed somewhat above ear level even when standing, so that they
are unlikely to be localized as people walk around the room.

dipolar surround placement

sub

L sur

R sur

R

C

L

If more traditional speakers are used, they should be placed such that their out-
put is scattered across the rear of the room. (See diagram, next page.) Often, the
best results will be obtained by placing them relatively high and slightly behind
the listener, cross-firing across the rear wall so as to create a large number of re-
flections with relatively little direct sound arriving at the listening position.

Advertising