Remote control advanced features – Proceed PAV User Manual
Page 61
61
Remote Control
Advanced Features
After you set up the remote control to operate your equipment, you can also
program advanced features on the remote control. The advanced features are
designed to enhance the use of the remote control with your home entertain-
ment system.
punch-throughs
volume control
“punch-through”
The PAV/PDSD’s remote may be programmed to operate the
volume + –
controls
and
mute
button from either the TV or PAV to operate in conjunction with any of
the eight devices controlled by the remote. For example, since the PAV will likely
be used as the sound system for TV viewing, you may wish to have the PAV’s
volume activated when the remote is set to run the TV. Either the AUDIO or TV
volume control may be associated with any of the remote’s devices.
NOTE:
When this feature is active, the AUDIO or TV volume and mute will
override any existing volume controls in that mode.
To program the remote for Volume Punch-Through, follow these steps:
1
Select the mode that you wish to program for Volume Control
“Punch-Through.”
2
Press the corresponding Device button (e.g.,
tv
,
sat
, etc.) and
the
mute
button simultaneously.
SET
will appear in the LCD.
3
Press the
adjust +
button.
PUNCH
will appear in the LCD.
4
Press either the
pav/audio
or
tv
Device selector, depending on
which system’s volume control you wish to have attached for
the punch-through mode.
AUDIO
or
TV
will flash in the LCD.
Example:
To have the PAV’s volume control be activated even though the
remote is set to control TV, first press the
tv
Device control selector, and the
mute
button at the same time. Next press the
adjust +
button, followed by the
pav/audio
Device control selector.
To return to the original setting, follow these steps:
1
Select the mode that you want to turn off the Volume Control
“Punch-Through” and press the corresponding Device button
(e.g.,
tv
,
sat
, etc.) and the
mute
button simultaneously.
SET
will
appear in the LCD.
2
Press the
adjust +
button.
PUNCH
will appear in the LCD.
3
Press the same Device button again. The Device mode will
flash in the LCD.
The AUDIO or TV Volume Control “Punch-Through” is now turned off. The
VOLUME and MUTE of the original device will operate on the remote control.