ARRIS 2247-N8-10NA (v9.1.x) Admin Handbook User Manual
Page 28
Administrator’s Handbook
28
link-oid ("WAN") [ LAN | WAN | PPPoE | ]:
type (dhcpc) [ static | dhcpc | ppp ]: static
side (wan) [ lan | wan ]:
mcast-forwarding (off) [ off | on ]:
nat-enable (on) [ off | on ]:
rip-receive (off) [ off | v1 | v2 | v1-compat | v2-md5 ]:
icmp-echo-drop (on) [ off | on ]:
icmp-err-suppress (off) [ off | on ]:
fs-egress ("WanEgress") [ Security | QosUpstream | WanEgress | ]:
fs-ingress ("") [ Security | QosUpstream | WanEgress | ]:
static
ipaddr (""): 10.3.53.100
netmask ("255.255.255.0"):
NOS/128600225634272 (conn)>> set ip gateway address 10.3.53.1
NOS/128600225634272 (conn)>> save
If you do not want the gateway use this command to turn it off:
set ip gateway enable off
set conn name name static netmask netmask
Specifies a
static
netmask when the connection
type
has been set to
static
. The default is 255.255.255.0.
set conn name name dhcp-server start-addr ipaddr
If
dhcp-server-enable
is set to
on
, specifies the first address in the DHCP address range. The 2247-N8 can
reserve a sequence of up to 253 IP addresses within a subnet, beginning with the specified address for dynamic
assignment. The default is 192.168.1.64
set conn name name dhcp-server end-addr ipaddr
If
dhcp-server-enable
is set to
on
, specifies the last address in the DHCP address range. The default is
192.168.1.253
set conn name name dhcp-server lease-time lease-time
If
dhcp-server-enable
is set to
on
, specifies the default length for DHCP leases issued by the 2247-N8. The
lease time is in time format (DD:HH:MM:SS). The default is one day
(01:00:00:00)
.
set conn name name dhcp-server subnet-order [1... 8]
If
dhcp-server-enable
is set to
on
, specifies the order in which to address the first of 8 possible subnets. Ordi-
narily, this is the first one, the default
1
.
set conn name name nat-enable [ on | off ]
Specifies whether you want the 2247-N8 to use network address translation (NAT) when communicating with
remote gateways. NAT lets you conceal details of your network from remote gateways. It also permits all LAN
devices to share a single IP address. By default, address NAT is turned
on
.
set conn name name dhcp-client discover-time seconds
The DHCP client parameters appear when the connection
type
has been set to
dhcpc
.
discover-time
is in sec-
onds; the default is
30
.
set conn name name dhcp-client dns-enable [ on | off ]
This allows you to enable or disable the default behavior of acting as a DNS proxy. The default is
on
.