ARRIS 2247-N8-10NA (v9.1.x) Admin Handbook User Manual
Page 59
59
set physical dsl trellis [ on | off ]
Turns trellis error correction encoding on or off. Default is
on
.
set physical dsl nlnm-threshold [ 0 - 480 ]
Specifies the New Low Noise Model (NLNM) value between 0 and 480. Default is
60
.
set physical dsl transport [ atm ]
Sets the DSL transport modeto Asynchronous (
atm
). Default is
atm
.
set physical dsl atm vcc [ 1 - 8 ] enable [ off | on ]
Turns
atm
on or off on selected vcc 1 through 8. Default is
on
.
set physical dsl atm vcc [ 1 - 8 ] vpi [ 0 - 255 ]
Sets the Virtual Path Identifier (
vpi
) for the selected vcc. Default is
0
.
set physical dsl atm vcc [ 1 - 8 ] vci [ 32 - 65535 ]
Sets the Virtual Channel Identifier (
vci
) for the selected vcc. Default is
35
.
set physical dsl atm vcc [ 1 - 8 ] tx-queue queue_name
Attaches the egress queue template to the atm vc when the queue type is egress.
set physical dsl atm vcc [ 1 - 8 ] rx-queue queue_name
Attaches the ingress queue to the atm vc when the queue type is ingress.
set physical dsl atm vcc [ 1 - 8 ] auto-vpi-vci [ on | off ]
Turns Automatic VPI/VCI Detection on or off. If you leave the default
on
, the device will try a series of VPI/VCI
pairs that are commonly used by service providers. When one pair succeeds, the device will use this one for
future connections.
set physical dsl atm vcc [ 1 - 8 ] vpi-vci-list vpi_vci_pairs
Specifies the series of VPI/VCI pairs that the device will use to attempt a connection. The default set ("0/35 8/35
0/43 0/51 0/59 8/43 8/51 8/59") may changed. The list is the default.
set physical dsl atm vcc [ 1 - 8 ] qos enable [ off | on ]
Turns QoS off or on on the virtual circuit. Default is
off
.