ARRIS 2247-N8-10NA (v9.1.x) Admin Handbook - Manual (Page 38)

Administrator’s Handbook
38
ip6 conn
set ip6 conn name name enable [ on | off ]
Enables/disables the IPv6 connection named name . The default is off.
set ip6 conn name name type [ static | rd | autoconf | dp | aiccu | ip6in4 | local ]
Specifies the type of tunnel for the IPv6 tunnel. The default is static.
set ip6 conn name name mtu [ 1280 - 1500 ]
Specifics the size of the maximum transfer unit. The default is 1500.
set ip6 conn name name side [ lan | wan ]
Specifies which connection uses tunnelling. The default is wan.
set ip6 conn name name mcast-forwarding [ off | on ]
Specifies the multicast forwarding is enabled for the tunnel. The default is on.
set ip6 conn name name icmp-echo-drop [ off | on ]
If enabled, all ICMP echo requests coming from the Internet will be dropped. The default is off.
set ip6 conn name name old-prefix-purge-timer
The time in seconds for which old, invalid prefixes are advertised with a lifetime of zero. The intent is to “flush
out” global prefixes on attached IPv6 hosts which suddenly become invalid.
set ip6 conn name name traffic-class-clear [ off | on ]
Specifies the traffic class. The default is off.
Static Connections
ip6 conn (type = static): Statically configured IPv6 connection.
set ip6 conn name name static link-oid link_name
Sets the connection named name to point to an associated link specified by the link-oid link_name .
set ip6 conn name name static ipaddr ipv6_address
Specifies a static IPv6 address.
set ip6 conn name name static prefix-length value
Specifies the prefix length of the connection's static IPv6 address. Default is 64 .
6rd Connections
ip6 conn (type = rd, side = wan): This WAN connection type is a 6rd tunnel over an IPv4 conn in accordance
with RFC 5569.