Overview – ARRIS 2247-N8-10NA (v9.1.x) Admin Handbook User Manual
Page 9
9
Overview
The CLI has two major command modes:
SHELL
and
CONFIG
.
Summary tables
that list the commands are
provided below. Details of the entire command set follow in this section.
SHELL Commands
Command
Status and/or Description
arp
to send ARP request
atmping
to check the ATM connection reachability and network
connectivity.
clear
to erase all stored configuration information
clear_certificate
to remove an SSL certificate that has been installed
clear_https_certkey
to remove a secure HTTP certificate key value
clear_firewall_log
to empty the contents of the firewall event log
clear_igmp_log
to empty the contents of the igmp log
clear_log
to erase all stored log info in flash memory
configure
to configure unit's options
debug
to activate or deactivate debug
diagnose
to run self-test
download
to download config file
exit
to quit this shell
help
to get more: “help all” or “help help”
install
to download and program an image into flash
log
to add a message to the diagnostic log
loglevel
to report or change diagnostic log level
netstat
to show IP information
nslookup
to send DNS query for host
ping
to send ICMP Echo request
quit
to quit this shell
6rd-check
to send a 6rd loopback packet to the border gateway
remote-access
to activate or deactivate remote access
reset
to reset subsystems
restart
to restart unit
show
to show system information
start
to start subsystem
status
to show basic status of unit
telnet
to telnet to a remote host
traceroute
to send traceroute probes
upload
to upload config file
view
to show configuration information
who
to show who is using the shell
wps
to enter Wireless Protection Settings mode