ARRIS 2247-N8-10NA (v9.1.x) Admin Handbook - Manual (Page 61)

61
set physical ensw qos-mode [ off | p-bit ]
Sets QoS up on Ethernet switch, classified by priority-bit mapping. Default is off . When p-bit is selected, pack-
ets will be mapped from their priority (even if untagged) to one of four queues per-port in the Ethernet switch.
Wireless interfaces
set physical wireless enable [ on | off ]
Enables or disables the wireless capability for supported Wi-Fi Gateways. Default is on .
set physical wireless standard [ bg | b-only | g-only | bgn | n-only | an | a-only ]
Sets and locks the gateway into the wireless transmission mode you want: bg , b-only , g-only , bgn , n-only , an ,
or a-only . For compatibility with clients using 802.11b (up to 11 Mbps transmission), 802.11g (up to 20+
Mbps), 802.11a (up to 54 Mbit/s using the 5 GHz band), or 802.11n (from 54 Mbit/s to 600 Mbit/s with the use
of four spatial streams at a channel width of 40 MHz), select
B/G/N . To limit your wireless LAN to one mode or
the other, select G-only , N-only , A-only , or B-only , or some combination that applies to your setup. Default is
bgn .
set physical wireless auto-channel [ off | on ]
Turns auto-channel selection on or off .
set physical wireless band-lock [ 2.4 | 5.0 ]
Sets the Wi-Fi radio to use only the 2.4 GHz or 5.0 GHz frequency bands. This only applies when in n-only
mode. The default is 2.4.
set physical wireless bandwidth [ narrow | wide ]
Specifies whether the Wi-Fi channel is narrow or wide band. Default is narrow in compliance with FCC require-
ments.
set physical wireless default-channel [ 1... 11 ]
(1 through 11, for North America) on which the network will broadcast. This is a frequency range within the
2.4Ghz band. Channel selection can have a significant impact on performance, depending on other wireless
activity close to this Router. Channel selection is not necessary at the client computers; the clients will scan the
available channels seeking access points using the same SSID as the client. Defaults to
6 .
set physical wireless power [ 1 - 100 ]
Sets some value lower than 100 percent transmit power if your gateway is located close to other Wi-Fi Gate-
ways and causes interference. Defaults to
100 (percent).
set physical wireless mul2uni [ off | on ]
Turns wireless “many-to-one” packet scheduling off or on . Default is off .
NOTE:
This only applies to packets sent from the host CPU to a switch port; it does not apply to port-to-port traffic.