Pppoe relay commands, Nat pinhole commands, Pppoe relay commands nat pinhole commands – ARRIS 2247-N8-10NA (v9.1.x) Admin Handbook User Manual
Page 63
63
set physical wireless wmm enable [ off | on ]
Enables or disables Wi-Fi Multimedia settings for multimedia queueing characteristics.
set physical wireless wmm power-save [ off | on ]
Turns power saving mode
off
or
on
for wireless multimedia when
wmm enable
is
on
. Default is
on
.
PPPoE relay commands
set pppoe-relay enable [ on | off ]
Allows the gateway to forward PPPoE packets. Default is
on
.
set pppoe-relay max-sessions [ 0... 4 ]
Specifies the maximum number of PPPoE relay sessions. Default is
4
.
NAT Pinhole commands
NAT pinholes let you pass specific types of network traffic through the NAT interfaces on the 2247-N8. NAT pin-
holes allow you to route selected types of network traffic, such as FTP requests or HTTP (Web) connections, to
a specific host behind the 2247-N8 transparently.
To set up NAT pinholes, you identify the type(s) of traffic you want to redirect by port number, and you specify
the internal host to which each specified type of traffic should be directed.
The following list identifies protocol type and port number for common TCP/IP protocols:
FTP (TCP 21)
telnet (TCP 23)
SMTP (TCP 25),
TFTP (UDP 69)
set pinhole name name enable [ off | on ]
Enables or disables the named NAT pinhole. The defualt is on.
set pinhole name name protocol [ tcp | udp | both ]
Specifies the identifier for the entry in the gateway's pinhole table. You can name pinhole table entries sequen-
tially (1, 2, 3), by port number (21, 80, 23), by protocol, or by some other naming scheme. Specifies the type of
protocol being redirected.
set pinhole name name ext-port-range [ 0 - 49151 ]
Specifies the first and last port number in the range being translated.
set pinhole name name int-addr ipaddr
Specifies the IP address of the internal host to which traffic of the specified type should be transferred.
NOTE:
When configuring a PPPoE connection, you must also configure the required PPPoE authentication details
(such as user name and password combinations) on the client computer.